Block Paving in Warrington
Block paving for driveways, paths, steps and patios, laid to pattern in your choice of colour and finish on a compacted sub-base, with kiln-dried sand locked into every joint and sunken paving lifted and relaid. Around nine miles from our Leigh base.
Block Paving for Warrington Gardens
Most people picture block paving as a driveway surface, but it is just as much a material for paths, edging and steps, and across north Warrington we lay it for all three. The pattern is chosen for the job, so herringbone goes where cars run because it locks under turning weight, while basketweave and stretcher bond suit a garden path or a small seating square. A contrasting border or a double course of edge blocks gives every run a clean, finished line.
We cover Warrington and the surrounding area: Winwick, Callands, Orford, Longford, Cinnamon Brow and beyond (WA2, WA3, WA5).
Get a Free Warrington Quote
What’s Included
Getting the colour right matters as much as the pattern, so we bring buff, brindle, charcoal and silver-grey samples to site and lay them dry before you settle on a blend. What holds it all together is out of sight: a compacted MOT Type 1 sub-base and concrete edge restraints round the perimeter, the two things that stop block paving spreading and rutting a few winters in. On the older Longford plots and the village gardens out at Winwick we set that base to the ground we actually find.
- Block paving for drives, paths, patios, steps and edging
- Herringbone, stretcher and basketweave bonds
- Full choice of block colour, size and finish
- Dug out and compacted MOT Type 1 sub-base
- Contrasting borders and edge courses set in concrete
- Sunken or spreading block paving lifted and relaid
- Joints locked with kiln-dried sand
How It Works
Block Paving in Warrington, FAQs
Yes, that is a common relaying job. We lift the sunken blocks, put the base and the edge restraint right so it cannot happen again, then relay and brush fresh kiln-dried sand into the joints. Nine times out of ten the original blocks go straight back down and come up like new.
Yes, a mowing strip or a block edge round a border is one of the neatest uses of the material, and it saves you trimming by hand every week. We bed the edge blocks on concrete so they hold their line, and match or contrast the colour to whatever paving they sit against.
Yes, and it suits patios well because the small units follow curves and let us work borders, banding and even a circle feature into the design. We lay it to a fall the same way we would flags, so water runs off rather than pooling, and the colour blend can be picked to sit with the house and the planting.
Herringbone laid at forty-five degrees interlocks so the blocks brace against each other under turning and braking, which is why we use it on driveways. Stretcher bond and basketweave are a little less load-tolerant but look great on paths and patios where there’s no vehicle weight. All of them need a proper edge restraint to stop the blocks creeping, whatever the pattern.
It depends on the area, the access and what we find when we dig, because the excavation and sub-base are a fair chunk of the price whatever blocks go on top. We price per job rather than a blanket rate per square metre, so you get an exact written figure after a free site visit before anything starts.